Owner's Manual - Page 181

For Outlander PHEV 2016.

Loading ...
Loading ...
Loading ...
l
The vehicle speed exceeds 8 km/h
(5 mph) with the parking brake applied.
CAUTION
l
In the situations listed below, brake perform-
ance may be compromised or the vehicle
may become unstable if brakes are applied
suddenly; consequently, avoid driving at
high speeds or applying the brakes suddenly.
Furthermore, the vehicle should be brought
to a stop in a safe location and to have it
checked.
The brake warning lamp does not illumi-
nate when the parking brake is applied or
does not turn off when the parking brake
is released.
The ABS warning lamp and brake warn-
ing lamp illuminate at the same time
For details, refer to “ABS warning lamp”
on page 7-29.
The brake warning lamp remains illumi-
nated during driving.
l
The vehicle should be brought to a halt in
the following manner when brake perform-
ance has deteriorated.
Depress the brake pedal harder than usual.
Even if the brake pedal moves down to
the very end of its possible stroke, keep it
pressed down hard.
Should the brakes fail, use regenerative
braking to reduce your speed and careful-
ly pull the parking brake lever.
Depress the brake pedal to operate the
stop lamp to alert the vehicles behind you.
Check engine warning lamp
E00502602938
This lamp is a part of an on-
board diagnostic system
which monitors the emis-
sions, engine control system.
If a problem is detected in
one of these systems, this
lamp illuminates or flashes.
Although your vehicle will usually be driva-
ble and not need towing, we recommend you
to have the system checked as soon as possi-
ble.
This lamp will also illuminate when the oper-
ation mode of the power switch is put in ON,
and goes off after the Plug-in Hybrid EV
System has started. If it does not go off after
the Plug-in Hybrid EV System has started,
we recommend you to have the vehicle
checked.
CAUTION
l
Prolonged driving with this lamp on may
cause further damage to the emission control
system. It could also affect fuel economy
and drivability.
l
If the lamp does not illuminate when the op-
eration mode is put in ON, we recommend
you to have the system checked.
CAUTION
l
If the lamp illuminates while the Plug-in Hy-
brid EV System is operating, avoid driving
at high speeds and have the system inspected
by a MITSUBISHI MOTORS Authorized
Service Point as soon as possible.
NOTE
l
The engine electronic control module ac-
commodating the onboard diagnostic system
has various fault data (especially about the
exhaust emission) stored.
This data will be erased if a auxiliary battery
cable is disconnected which will make a rap-
id diagnosis difficult. Do not disconnect a
auxiliary battery cable when the check engine
warning lamp is ON.
Auxiliary battery charge warn-
ing lamp
E00502702287
This warning lamp will illu-
minate when there is a fault
with the charging system of
the auxiliary battery.
Warning lamps
6-45
OGGE16E1
Instruments and controls
6
Loading ...
Loading ...
Loading ...