Owner's Manual - Page 50

For Outlander PHEV 2016.

Loading ...
Loading ...
Loading ...
If the charging indicator is not illumina-
ted, charging is not started.
Follow the manual of each quick charg-
er.
NOTE
l
When the quick charge connector is connec-
ted to the charge port, the charging indicator
is blinking. When charging is started, the
charging indicator is illuminated.
NOTE
l
If you want to confirm the drive battery level
during charging, open one of the doors or
operate the multi information display switch,
the drive battery level display (F) appears in
the multi information display.
Although the predicted charging time dis-
play (G) blinks, the charging time for the
quick charging is about 30 minutes and dis-
played “--:--” in the screen and you cannot
confirm the remaining charging time.
l
Operation noise may be heard from the vehi-
cle body during quick charging.
This noise comes from the operation of the
drive battery cooling system, and it is not a
malfunction.
l
Since the drive battery cooling system uses
cool air of the air conditioning, the air condi-
tioning is automatically operated.
After quick charging, if the area under the
vehicle is wet, transparent and loose, it is de-
humidified water from the air conditioning
and not a malfunction.
7. Charging is complete when the charging
indicator turns off.
Disconnect the quick charge connector
according to the manual of the quick
charger.
CAUTION
l
As the quick charge connector is heavier in
comparison to the normal charge connector,
allowing it to drop could cause damage to
the vehicle or charge connector or personal
injury. When removing the connector, be
sure to pull it out straight and as carefully as
possible.
l
Do not leave the quick charge connector
connected to the quick charge port after
charging.
Doing so, someone might stumble and it
could cause an injury or the quick charge
port might be damaged by playing it.
NOTE
l
Although it is possible to start the electric
motor unit if quick charging has not finished
normally, the charging indicator is continu-
ously blinking. In such a situation, perform
quick charging again and finish it normally
or contact a MITSUBISHI MOTORS Au-
thorized Service Point.
8. Close the inner lid and press the rear of
the normal charging lid until it clicks to
close it.
Quick charging (charging method with quick charger)*
3-18
OGGE16E1
Charging
3
Loading ...
Loading ...
Loading ...