Loading ...
Loading ...
Loading ...
Removing Disc
1 Set the power switch to "OFF'
to turn the DVD Video Camera
off.
/ Press down the DIS(? EJECT
lever once and release it.
In a moment, the coxer of disc
insertion compartment will
open slightly.
3 Gently, open the cover until it
stops.
_,_,Nenthe cover is fully open,
the disc will slightly come out
_om the disc guide, and stop.
Note:
• Even after the DVD Video Camera is turned on, the disc
can be removed unless it is in recording status. Hold
down the DISC EJECT lever for approximately 2
seconds, and then release it to remove the disc. (The
DiSC EJECT indicator on the LCD screen will blink.) It is
recommended that you turn the DVD Video Camera off
before inserting or removing disc to prevent
misoperation.
• Do not remove the battery pack or disconnect the AC
adaptor during removal of the disc or until power is
completely turned off: If you do, the disc cover will not
open. If this happens, reattach the battery pack or AC
adaptor, push down the DISC EJECT lever once, and
then release it.
• Do not insert anything other than the 8 cm DVD-RAM or
DVD-R disc into the disc insertion block: Doing so could
cause malfunctions.
• Set the power switch to "OFF" to turn the DVD Video
Camera off.
• When inserting or removing the disc, be careful not to
touch the inside of DVD Video Camera [especially, the
lens of laser pickup (see "Terminology" on page 148 )].
• When inserting or removing the disc, connect a charged
battery pack or AC adaptor to the DVD Video Camera:
The disc cover will not open unless the DVD Video
Camera is powered.
4Remove the disc. _,
Hold the top of Round
DVD Holder as shown in
the illustration and
gently pull it ore.
Note:
Be careful not to touch the
exposed disc portion
when removing the disc
When grasping the holder,
avoid the exposed disc
portion.
5 Gently push the section
indicated "PUSH (?LOSE"
on the cover of disc insertion
compamnent (on side) to
close the cover.
48
Loading ...
Loading ...
Loading ...