Loading ...
Loading ...
Loading ...
SDS6000L User Manual
1 9 8 i n t . s i g l e n t . c o m
The following screenshot shows the peaks of the FFT waveform:
Measure the FFT waveform
Turn on the cursor function, and then specify the source as "Fx". X1 and X2 cursors can be used to
measure the frequency value at the cursor position.
Only the “maximum” parameter of the FFT is supported in automatic measurement.
Note:
DC components in the signal may show a large amplitude near 0 Hz. If
your application does not require measurement of the DC component, it is
recommended to set the coupling mode of the source channel to "AC".
17.6 Formula Editor
Click Formula Editor in the operation setting page to recall the editor:
Loading ...
Loading ...
Loading ...