Siglent SDS6000L User Manual

Loading ...

SDS6000L User Manual

int. s i g l e n t . c o m 1 2 1

If you set the trigger condition to 7 address & data or 10

address & data:

 Address can be selected in the hexadecimal

range of 0x00 to 0x7F (7-bit) or 0x3FF (10-bit). If the

address is selected as "0xXX (7-bit address)" or

"0xXXX (10-bit address)", the address is ignored. It

will always trigger on the Ack bit followed by the

address.

 Data1 and Data2 can be selected in the

hexadecimal range of 0x00 to 0xFF. If the data is

selected as "0xXX", the data is ignored. It will

always trigger on the Ack bit followed by the

address.

 R/W Bit can be specified as Write, Read, or Don't

Care.

Data Length

-- The data length range is 1 to 12 bytes. When the SDA data length is equal to the value

of Data Length and address length is the same as the set value, the oscilloscope will be triggered.

 Click the Address Length to select "7-bits" or "10-bits" to match the address of the input signal.

 Click the Data Length and roll the mouse wheel or use the virtual keypad to set the data length

to match the data length of the input signal.

Loading ...

Siglent SDS6000L Low Profile Digital Oscilloscope