Loading ...
Loading ...
Loading ...
SDS6000L User Manual
1 6 4 i n t . s i g l e n t . c o m
A. Set the source of the current setting.
B. Measurement parameter classification tabs, including Favorite, Vertical, Horizontal,
Miscellaneous, and CH Delay. Click a tab and the area will display the corresponding
parameters
C. Parameters. Click the parameter to be measured to activate it, and click it again to close the
parameter.
D. Background highlighted parameters represent it is activated. In the figure above, "Pk-Pk" and
"ROV" are activated.
E. Description of the last selected parameter.
The correct steps to add a measurement parameter are to select the source in the area and
then select the parameter in the area. For example, to add Pk-Pk measurements for C1 and
Period measurements for C2, follow the steps below:
Source > C1 > Vertical > Pk-Pk
Source > C2 > Horizontal > Period
For the channel delay (CH Delay) measurement, because the number of sources involved is greater
than 1, the steps to specify the source are different:
In the parameter selection area, the channel corresponding to Source A is specified first, and then
the channel corresponding to Source B . Finally, the measurement parameter is selected. For
example, to activate the skew between C1 and C2, you can follow the following steps:
Source A > C1 > Source B > C2 > Skew
Loading ...
Loading ...
Loading ...