Loading ...
Loading ...
Loading ...
198
6.1.2 Setting up Input and Output Devices
After adding the I/O device, enable the input and output device. For GV-I/O Boxes connected through
USB, you can configure the signal type on GV-VMS. For GV-IP Devices and GV-I/O Boxes connected
through a network, you will have to configure the signal type on the device’s Web interface.
[Input X] Click the Arrow buttons to select the input device and click Enable.
Select Input Apply to all Inputs
Sync Web UI
Figure 6-3
Name: Name each input pin. The left Arrow button allows you to sync the name with that on the
I/O device’s Web interface.
Signal Type: Select a signal type for your input device: NO (normally open), NC (normally close)
or Latch Trigger. For details on Latch Trigger, see Latch Trigger later in this chapter.
[Output X] Click the Arrow buttons to select the output device and click Enable.
Figure 6-4
Name: Name each output pin. The left Arrow button allows you to sync the name with that on the
I/O device’s Web interface.
Loading ...
Loading ...
Loading ...