Loading ...
Loading ...
Loading ...
WARNING!
•
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off
the road to avoid the danger of being hit when
operating the jack or changing the wheel.
•
Being under a jacked-up vehicle is dangerous. The
vehicle could slip off the jack and fall on you. You
could be crushed. Never put any part of your body
under a vehicle that is on a jack. If you need to get
under a raised vehicle, take it to a service center
where it can be raised on a lift.
•
Never start or run the engine while the vehicle is
on a jack.
•
The jack is designed to be used as a tool for
changing tires only. The jack should not be used to
lift the vehicle for service purposes. The vehicle
should be jacked on a firm level surface only. Avoid
ice or slippery areas.
NOTE:
If your vehicle is equipped with an air suspension sys-
tem, there is a feature which allows the automatic level-
ing to be disabled before changing a tire. This feature
can be activated through the Uconnect system
page 200.
PREPARATIONS FOR JACKING
Before changing a tire or using the jack please disable
the hands free lift gate, This feature can be disabled
through the Uconnect system
page 182.
1. Park the vehicle on a firm, level surface as far from
the edge of the roadway as possible. Avoid icy or
slippery areas.
WARNING!
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off the
road to avoid being hit when operating the jack or
changing the wheel.
2. Turn on the Hazard Warning Flashers.
3. Apply the parking brake.
4. Place the gear selector into PARK (P).
5. Turn OFF the ignition.
6. Block both front and rear of the wheel diagonally
opposite of the jacking position. For example, if
changing the driver’s front tire, block the passen-
ger’s rear wheel.
NOTE:
Passengers should not remain in the vehicle when the
vehicle is being raised or lifted.
JACK AND TOOLS LOCATION
The scissor-type jack and tire changing tools are
located in the rear cargo area, under the load floor.
1. Lift up on the load floor handle to access the jack
and tool storage.
2. Remove the jack storage cover to access the jack
and tools.
Wheel Blocked Example
Load Floor Handle
Jack And Tools Access Cover
276 IN CASE OF EMERGENCY
Loading ...
Loading ...
Loading ...