Loading ...
Loading ...
Loading ...
All doors can be programmed to unlock on the first
push of the unlock button through Uconnect Settings
page 182.
Using The Panic Feature
To turn the Panic feature on or off, push the Panic but-
ton on the key fob. When the Panic feature is activated,
the turn signals will flash, the horn may pulse on and
off (if equipped with horn alarm), and the interior lights
will turn on.
The Panic feature will stay on for three minutes unless
you turn it off by either pushing the Panic button a sec-
ond time or drive the vehicle at a speed of 15 mph
(24 km/h) or greater.
NOTE:
•
The interior lights will turn off if you place the igni-
tion in the ON/RUN position while the Panic feature
is activated. However, the exterior lights and horn
(if equipped with horn alarm) will remain on.
•
You may need to be closer than 66 ft (20 m) from
the vehicle when using the key fob to turn off the
Panic feature due to the radio frequency noises
emitted by the system.
Key Left Vehicle Feature
If a valid key fob is no longer detected inside the vehicle
while the vehicle’s ignition system is in the ON/RUN or
START position, the message “Key Fob Has Left The
Vehicle” will be shown in the instrument cluster display
along with an interior chime. An exterior audible and
visual alert will also be activated to warn the driver.
The vehicle’s horn will rapidly chirp three times along
with a single flash of the vehicle’s exterior lights.
NOTE:
•
The doors have to be open and then closed in order
for the vehicle to detect a key fob. The Key Left
Vehicle feature will activate when the first door is
closed and no key fob is detected in the vehicle. If
the warning has been activated, and the other doors
are closed, no other warnings will be issued.
•
These alerts will not be activated in situations where
either the vehicle’s engine is left running with the
key fob inside, or the key fob’s wireless signals are
blocked.
Air Suspension (Remote Lowering Of
The Vehicle) — If Equipped
For easy entry and loading, your vehicle can
be lowered to Entry/Exit height by pushing
the key fob air suspension button two times.
When air suspension lowering is requested
using the key fob, the vehicle will send a series of
chirps and flashes (when enabled within Uconnect Set-
tings) to alert the customer that the operation has
begun and will continue these alerts until it success-
fully lowers.
The following conditions must be met for the vehicle to
lower remotely:
•
The vehicle must not already be in Entry/Exit (Park)
ride height.
•
The vehicle battery must be fully charged.
•
All doors must be closed.
•
The key fob must be out of the vehicle.
NOTE:
Ensure the vehicle is clear of all objects, pets, and
people prior to remote lowering.
Canceling Remote Lowering
Vehicle lowering can be canceled at anytime. When
vehicle lowering is canceled, the vehicle will raise up to
the next defined level and lock out the remote lowering
feature for five seconds before a new request can be
made.
To cancel vehicle lowering, push the key fob air suspen-
sion button one time during the lowering process. When
vehicle lowering is canceled, the horn will chirp two
times and the turn signals will flash four times. Once
raising is completed, the horn will chirp one time.
NOTE:
For more information on Air Suspension, see
page 125.
Replacing The Battery In The Key Fob
The replacement battery model is one CR2450 battery.
NOTE:
•
Customers are recommended to use a battery
obtained from Mopar®. Aftermarket coin battery
dimensions may not meet the original OEM coin
battery dimensions.
•
Perchlorate Material — special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
for further information.
•
Do not touch the battery terminals that are on the
back housing or the printed circuit board.
•
Do not replace the coin battery if the LED on the key
fob above the top row buttons blinks when a button
is pressed. The coin battery should last a minimum
of three years with normal vehicle usage.
18 GETTING TO KNOW YOUR VEHICLE
Loading ...
Loading ...
Loading ...