Loading ...
Loading ...
Loading ...
•
When searching for a parking space, the driver
should drive as parallel or perpendicular (depending
on the type of maneuver) to other vehicles as
possible.
•
While the vehicle is in DRIVE, there will be a full
screen image in the Uconnect display. If the driver
shifts to REVERSE while searching for a parking
space, a camera image will appear in the Uconnect
display with a “Shift To Drive” message.
Both types of valid spaces (parallel and perpendicular)
will be displayed in the Uconnect display as they are
found. The available spaces will update in real time.
When valid parking spaces have been found, the driver
will be prompted to stop the vehicle.
The driver can then select a parking space by pressing
the desired space on the Uconnect display.
NOTE:
If a space selection is attempted before the vehicle is
stopped, a warning screen will appear in the Uconnect
display with instructions to stop the vehicle to make a
selection.
If the driver selects a perpendicular parking space, the
system will prompt the driver to choose a Forward or
Reverse parking method.
NOTE:
You can press the “Back” button on the display to
return to the parking space selection screen and select
a different space.
Once the parallel or perpendicular parking maneuver
selection has been made, a message will appear in the
display with instructions to hold down the brake pedal
and Active Park Assist switch. Both of these conditions
must be met in order to begin the parking maneuver.
The message also instructs the driver to push and hold
the Active Park Assist switch for the entire maneuver.
NOTE:
When the Active Park Assist switch is held down, the
turn signal for the side of the vehicle where the
selected parking space is located will turn on
automatically.
The system will then instruct the driver to remove
hands from the steering wheel and feet from the ped-
als. This screen will be shown for a minimum of two
seconds, or until the driver releases the brake pedal.
When the parking sequence is initiated by the driver
after the previously described conditions are met, the
Uconnect system will display a Top View along with
either a rear camera view (if the vehicle is placed in
REVERSE) or a forward camera view (if the vehicle is
placed in DRIVE).
The Top View will have integrated ParkSense arcs in the
image at the front and rear of the vehicle. The arcs will
change color from yellow to red corresponding the dis-
tance zones to the oncoming object.
The system will then perform the parking maneuver.
Once the maneuver is complete, the vehicle will auto-
matically shift into PARK.
The system will display a “Complete!” message and
instruct the driver to release the Active Park Assist
switch.
Once the Active Park Assist switch is released, a chime
will sound and the LED on the switch will turn off. After
approximately five seconds, the previous Uconnect
screen will display.
NOTE:
•
It is the driver's responsibility to use the brake and
stop the vehicle. The driver should check their sur-
roundings and be prepared to stop the vehicle either
when instructed to, or when driver intervention is
required.
•
When the system instructs the driver to remove their
hands from the steering wheel, the driver should
check their surroundings and begin to back up
slowly.
Select A Space
Choose Perpendicular Parking Method
STARTING AND OPERATING 147
4
Loading ...
Loading ...
Loading ...