Loading ...
Loading ...
Loading ...
•
The system will cancel the maneuver if the vehicle
speed exceeds 28 mph (40 km/h) during active
steering guidance into the parking space. The sys-
tem will provide a warning to the driver at 28 mph
(40 km/h) that tells them to slow down. The driver is
then responsible for completing the maneuver if the
system is canceled.
•
If the system is canceled during the maneuver for
any reason, the driver must take control of the
vehicle.
WARNING!
•
Drivers must be careful when performing parallel
or perpendicular parking maneuvers even when
using the ParkSense Active Park Assist system.
Always check carefully behind and in front of your
vehicle, look behind and in front of you, and be
sure to check for pedestrians, animals, other
vehicles, obstructions, and blind spots before
backing up and moving forward. You are respon-
sible for safety and must continue to pay attention
to your surroundings. Failure to do so can result in
serious injury or death.
•
Before using the ParkSense Active Park Assist sys-
tem, it is strongly recommended that the ball
mount and hitch ball assembly be disconnected
from the vehicle when the vehicle is not used for
towing. Failure to do so can result in injury or dam-
age to vehicles or obstacles because the hitch ball
will be much closer to the obstacle than the rear
fascia/bumper when the vehicle sounds the con-
tinuous tone. Also, the sensors could detect the
ball mount and hitch ball assembly, depending on
its size and shape, giving a false indication that an
obstacle is behind the vehicle.
CAUTION!
•
The ParkSense Active Park Assist system is only a
parking aid and it is unable to recognize every
obstacle, including small obstacles. Parking curbs
might be temporarily detected or not detected at
all. Obstacles located above or below the sensors
will not be detected when they are in close
proximity.
•
The vehicle must be driven slowly when using the
ParkSense Active Park Assist system in order to be
able to stop in time when an obstacle is detected.
It is recommended that the driver looks over his/
her shoulder when using the ParkSense Active
Park Assist system.
Parallel Park Exit
Enable the ParkSense Active Park Assist system by
pressing the ParkSense Active Park Assist switch. To
initiate a parking space exit maneuver, the vehicle must
be stopped, and the driver must press “Exit” on the
Uconnect display.
After the driver chooses a parallel park exit maneuver,
the system will then prompt the driver to choose an exit
method. The exit method options are Forward Left and
Forward Right.
NOTE:
If an exit method selection is attempted before the
vehicle is stopped, the driver will be instructed to stop
the vehicle to make a selection.
After the driver chooses a parallel exit side, a message
appears in the Uconnect display with instructions to
hold the brake pedal and hold down the Active Park
Assist switch. Both of these conditions must be met
before the maneuver can begin.
When the Active Park Assist switch is held down, the
turn signal for the chosen exit side will turn on
automatically.
The system will then instruct the driver to remove
hands from the steering wheel and feet from the ped-
als. This screen will be shown for a minimum of two
seconds, or until the driver releases the brake pedal.
When the exit sequence is initiated by the driver after
the previously described conditions are met, the
Uconnect system will display a Top View along with
either a rear camera view (if the vehicle is placed in
REVERSE) or a forward camera view (if the vehicle is
placed in DRIVE), and the exit maneuver will begin.
Choose Exit Method
148 STARTING AND OPERATING
Loading ...
Loading ...
Loading ...