Loading ...
Loading ...
Loading ...
NOTE:
These features will stay on through the duration of
Remote Start, or until the ignition is placed in the
ON/RUN position. The climate control settings will
change, and exit the automatic defaults, if manually
adjusted by the driver while the vehicle is in Remote
Start mode. This includes turning the climate controls
off using the OFF button.
REMOTE START WINDSHIELD
WIPER DE-ICER ACTIVATION —
IF EQUIPPED
When Remote Start is active and the outside ambient
temperature is less than 33°F (0.6°C), the Windshield
Wiper De-Icer will activate. Exiting Remote Start will
resume its previous operation. If the Windshield Wiper
De-Icer was active, the timer and operation will continue.
REMOTE START ABORT MESSAGE
One of the following messages will display in the instru-
ment cluster display if the vehicle fails to remote start
or exits Remote Start prematurely:
•
Remote Start Canceled — Door Open
•
Remote Start Canceled — Hood Open
•
Remote Start Canceled — Liftgate Open
•
Remote Start Canceled — Fuel Low
•
Remote Start Canceled — Time Expired
•
Remote Start Canceled — System Fault
•
Remote Start Disabled — Start Vehicle to Reset
The instrument cluster display message stays active
until the ignition is placed in the ON/RUN position.
VEHICLE SECURITY SYSTEM —
IF EQUIPPED
The Vehicle Security system monitors the vehicle doors,
hood, liftgate, and the Keyless Enter ‘n Go™ Ignition for
unauthorized operation. While the Vehicle Security sys-
tem is armed, interior switches for door locks and lift-
gate release handle are disabled. If something triggers
the alarm, the Vehicle Security system will provide the
following audible and visible signals:
•
The horn will pulse
•
The turn signals will flash
•
The Vehicle Security Light in the instrument cluster
will flash
TO ARM THE SYSTEM
Follow these steps to arm the Vehicle Security system:
1. Make sure the vehicle’s ignition is placed in the OFF
position.
○
For vehicles equipped with Keyless Entry, make
sure the vehicle’s keyless ignition system is OFF.
2. Perform one of the following methods to lock the
vehicle:
○
Push the lock button on one of the front interior
power door lock switches with the driver and/or
passenger door open.
○
Touch the lock button on the exterior Passive
Entry door handle with a valid key fob available in
the same exterior zone
page 27.
○
Push the lock button on the key fob.
3. If any doors are open, close them.
When the Vehicle Security system is armed, the Vehicle
Security Light (located in the lower right portion of the
instrument cluster display) will begin to flash every two
seconds until it is disarmed.
NOTE:
•
If the system is armed by pushing the lock button on
the interior door panel, the Vehicle Security Light will
flash rapidly for about 15 seconds once the door is
closed, then slow down to every two seconds.
•
Pushing a lock button on the rear interior power
door lock switches will not arm the Vehicle Security
system.
TO DISARM THE SYSTEM
The Vehicle Security system can be disarmed using any
of the following methods:
•
Push the unlock button on the key fob.
•
Grab the Passive Entry door handle to unlock the
door
page 27.
•
Cycle the ignition out of the OFF position to disarm
the system.
NOTE:
•
The driver's door key cylinder cannot arm or disarm
the Vehicle Security system. Use of the door key cyl-
inder when the alarm is armed will sound the alarm
when the door is opened.
•
The Vehicle Security system remains armed when
the power liftgate is opened using the liftgate button
on the key fob. If someone enters the vehicle
through the opened liftgate, then opens any door
from the inside, the alarm will sound.
24 GETTING TO KNOW YOUR VEHICLE
Loading ...
Loading ...
Loading ...