Loading ...
Loading ...
Loading ...
Safety—Maintenance Precautions
MM16284,0001C53 -19-05OCT16-1/1
Practice Safe Maintenance
To avoid accidents:
•
Understand service procedures before starting work.
•
Keep the work area clean and dry.
•
Do not spray water or steam inside cab.
•
Never lubricate or service the machine while it is moving.
•
Keep hands, feet and clothing away from power-driven
parts.
Before servicing the machine:
1. Park the machine on a level surface.
2. Lower the bucket to the ground.
3. Turn the auto-idle switch off.
4. Run the engine at slow idle speed without load for 5
minutes.
5. Turn the key switch to OFF to stop engine.
6. Relieve the pressure in the hydraulic system by
moving the control levers several times.
7. Remove the key from the key switch.
8. Attach a “Do Not Operate” tag on the control lever.
9. Pull the pilot control shut-off lever to the LOCK position.
10. Allow the engine to cool.
•
If a maintenance procedure must be performed with the
engine running, do not leave the machine unattended.
•
If the machine must be raised, maintain a 90 to 110
degree angle between the boom and arm. Securely
support any machine elements that must be raised for
service work.
•
Inspect certain parts periodically and repair or replace
as necessary. Refer to the section discussing that part in
the "MAINTENANCE" chapter in the operator’s manual.
•
Keep all parts in good condition and properly installed.
•
Fix damage immediately. Replace worn or broken parts.
Remove any buildup of grease, oil, or debris.
•
When cleaning parts, always use nonammable
detergent oil. Never use highly ammable oil such as
fuel oil and gasoline to clean parts or surfaces.
•
Turn the battery disconnect switch to OFF before
adjusting the electrical systems or performing welding
operation on the machine.
•
Sufciently illuminate the work site. Use a maintenance
work light when working under or inside the machine.
•
Always use a work light protected with a guard. In case
the light bulb is broken, spilled fuel, oil, antifreeze uid,
or window washer uid may catch re.
TX1094263 —UN—28JUN13TX1094264 —UN—28JUN13TX1094265 —UN—28JUN13
1-4-1
112321
PN=59
Loading ...
Loading ...
Loading ...