Loading ...
Loading ...
Loading ...
Maintenance—Every 10 Hours or Daily
KR46761,000138B -19-14DEC16-3/3
Fill Procedure for Hydraulic Oil Transfer
Pump—If Equipped
1. Open right front service door to access the hydraulic
oil transfer pump.
2. Insert 4 mm hex wrench (2) into hole (3) and turn
counterclockwise to release locking pin.
CAUTION: Avoid personal injury from
high-pressure uid. High-pressure release
of oil from pressurized system can cause
serious burns or penetrating injury. Relieve
pressure by slowly turning hydraulic tank cap
(1) counterclockwise a few degrees.
To prevent possible burn injury from hot
hydraulic oil, wait for hydraulic oil to cool
before starting work.
3. Slowly turn hydraulic tank cap (1) counterclockwise a
few degrees to relieve pressure.
4. Place transfer pump hose (6) in hydraulic oil supply
container.
IMPORTANT: Prevent possible machine damage.
The hydraulic oil transfer pump is intended
only for topping off the hydraulic tank. Only
run for 8 minutes maximum.
5. Press and hold transfer pump switch (7) to run the
hydraulic oil transfer pump and to ll the tank with
fresh oil. See Hydraulic Oil. (Section 3-1.)
6. Release transfer pump switch when oil is between
marks on sight glass.
7. Return transfer pump hose to stored position.
8. Install hydraulic tank cap to case assembly (4) using
aligning marks (5) and turning cap clockwise to lock
position.
9. Close service door.
1— Hydraulic Tank Cap
2— Hex Wrench
3— Hole
4— Case Assembly
5— Aligning Mark (2 used)
6— Transfer Pump Hose
7— Transfer Pump Switch
TX1217817 —UN—20JUN16
Hydraulic Tank
1
4
3
2
5
TX1217692 —UN—22JUN16
Hydraulic Tank Cap
TX1224461 —UN—26SEP16
Hydraulic Oil Transfer Pump
3-4-5
112321
PN=220
Loading ...
Loading ...
Loading ...