Loading ...
Loading ...
Loading ...
Operation—Operator's Station
KR46761,0001158 -19-11JAN17-1/1
OUT4001,000077E -19-19FEB18-1/1
Adjusting the Mechanical Suspension
Seat—If Equipped
CAUTION: Prevent possibly injury. Do not adjust
seat settings while operating the machine.
While sitting on seat, push down on seat angle lever (1) to
adjust seat to desired angle. Release lever.
Pull up on seat fore-and-aft handle (2) to unlock seat.
Slide seat to desired distance from pilot control levers.
Release handle.
Turn weight adjustment knob (3) to adjust seat to weight
of operator.
Squeeze lumbar ball (4) to add air for rmness to lower
backrest area. Press button on bottom of lumbar ball to
release air and decrease rmness.
Pull up on backrest lever (5) to release backrest lock.
Move backrest to desired position. Release lever.
Pull headrest (6) upward or push downward to desired
height. Move headrest to desired angle.
Pull up on armrest (7) to move armrest out of the way
when exiting the cab.
Turn armrest dial (8) to adjust angle of armrest.
Pull seat and console handle (9) up toward operator. Slide
entire seat and consoles to desired distance from travel
pedals and levers. Release handle.
TX1000836A —UN—29NOV05
Mechanical Suspension Seat
T140133 —UN—02MAY01
Adjusting the Seat
1— Seat Angle Lever
2— Seat Fore-and-Aft Handle
3— Weight Adjustment Knob
4— Lumbar Ball
5— Backrest Lever
6— Headrest
7— Armrest
8— Armrest Dial
9— Seat and Console Handle
Adjusting Pilot Control Lever Console Height
1. Ensure engine is off and pilot shutoff lever is in locked
(UP) position.
CAUTION: Avoid possible crushing injury
from console unexpectedly dropping. Before
loosening the cap screws (1), support the console.
2. Remove right console holding cap screws (1).
3. Loosen cap screw (2) and adjust the pilot control lever
console height relative to the cab oor.
4. Install holding cap screws in holes for desired console
height and tighten.
5. Tighten cap screw to specication.
Specication
Cap Screw—Torque......................................................................50 N·m
37 lb·ft
TX1087326A —UN—25JAN11
Right Side of Seat Shown
1— Holding Cap Screw (2 used) 2— Cap Screw
6. Repeat procedure for left console.
2-1-28
112321
PN=121
Loading ...
Loading ...
Loading ...