Loading ...
Loading ...
Loading ...
Maintenance—Every 1000 Hours
Continued on next page KR46761,0001253 -19-12JUL16-1/2
Replace Hydraulic Tank Oil Filter
1. Park and position machine with arm cylinder fully
retracted and bucket cylinder (if equipped) fully
extended.
IMPORTANT: Turbocharger can be damaged
if procedure to shut down engine is
not done properly.
2. Run engine at slow idle speed without load for 5
minutes.
3. Stop engine.
4. Insert 4 mm hex wrench (2) into hole (3) and turn
counterclockwise to release locking pin.
CAUTION: Avoid personal injury from
high-pressure uid. High-pressure release
of oil from pressurized system can cause
serious burns or penetrating injury. Relieve
pressure by slowly turning hydraulic tank cap
(1) counterclockwise a few degrees.
To prevent possible burn injury from hot
hydraulic oil, wait for hydraulic oil to cool
before starting work.
5. Slowly turn hydraulic tank cap (1) counterclockwise a
few degrees to relieve pressure.
6. Hold down hydraulic oil lter cover (6) against light
spring load when removing the last two cap screws (7).
1— Hydraulic Tank Cap
2— Hex Wrench
3— Hole
4— Case Assembly
5— Aligning Mark (2 used)
6— Hydraulic Oil Filter Cover
7— Cap Screw (6 used)
TS281 —UN—15APR13
Pressurized Fluids
TX1217874 —UN—21JUN16
Hydraulic Tank
1
4
3
2
5
TX1217692 —UN—22JUN16
Hydraulic Tank Cap
3-10-2
112321
PN=241
Loading ...
Loading ...
Loading ...