Loading ...
Loading ...
Loading ...
Maintenance—Every 10 Hours or Daily
KR46761,00013A8 -19-27OCT16-1/1
Check Engine Oil Level
IMPORTANT: Prevent engine damage. DO NOT run
engine when oil level is below the ADD mark.
The most accurate oil level reading is obtained when the
engine is cold before starting the engine for the day’s
operation.
1. Park machine on a level surface.
IMPORTANT: Turbocharger can be damaged
if procedure to shut down engine is
not done properly.
2. Run engine at slow idle speed without load for 5
minutes.
3. Shut off engine and allow oil to drain into oil pan for
10 minutes.
4. Open engine cover to access engine.
5. Make sure dipstick (1) is fully seated.
6. Remove dipstick to check oil level.
BEFORE THE ENGINE IS STARTED: The engine
is full when oil level is in the cross-hatch area (3). It
is acceptable to run the engine when the oil level is
above the ADD mark.
AFTER THE ENGINE HAS BEEN RUN: Allow the oil
to drain into the oil pan for 10 minutes before checking
the oil level. Ten minutes after shutdown, the engine
oil level must be above the ADD mark.
7. If oil level is below ADD mark, add oil as necessary.
See Diesel Engine Oil—Final Tier 4 and Stage IV.
(Section 3-1.)
IMPORTANT: Avoid engine damage. Make sure that
area around and above engine oil ller cap (2) is
clean and clear of debris before removing cap.
TX1224394 —UN—05OCT16
Engine Oil Dipstick and Filler Cap
FULL
3
ADD
T216546 —UN—29NOV05
Cross-Hatch Area
1— Dipstick
2— Filler Cap
3— Cross-Hatch Area
8. If necessary, remove ller cap (2) to add oil.
9. Install ller cap and dipstick.
10. Close engine cover.
3-4-1
112321
PN=216
Loading ...
Loading ...
Loading ...