Loading ...
Loading ...
Loading ...
DPO6000, MPO6000 Series Digital Fluorescent Oscilloscope Product Manual V1.3
82
Load impedance can set the load input impedance of the signal source. You can
choose "High impedance" or "50Ω".
9. Align phase
Press WaveGen-> Align phase on the front panel.
After pressing “Align phase”, the signal source channel will be reconfigured so that it
will output according to the set frequency and phase. For two signals with the same
frequency or multiples, this operation can align their phases.
10. Modulation
Press the front panel WaveGen-> Modulation
For specific introduction to the modulation function, please refer to the section
"Modulation".
11. Burst
Press the front panel WaveGen -> Burst
For a detailed introduction to the burst function, please refer to the "Burst" section.
12. Duty
The duty is used only for square waves, and represents the amount of time the wave-
form is high during each cycle. It is 0.001% -99.996% at low frequencies and the range
will be reduced at higher frequencies.
13. Impedance
Impedance applies only to triangle waves, meaning that the triangle wave is the
amount of time to rise in each cycle.
14. Pulse width
Set the pulse width.
15. Pulse leading/trailing
Set the leading and trailing edges of the pulse wave.
Edit arbitrary waveform
Edit the arbitrary waveform in the oscilloscope's waveform generator interface. First,
double-click "Wave Editor Setup.exe" in the waveform editor folder on the CD-ROM
and install the arbitrary waveform editor according to the installation wizard. After suc-
cessful installation, the “WaveEditor” icon can be seen on the computer desktop. Dou-
ble-click the icon to enter the arbitrary waveform editing window.
Loading ...
Loading ...
Loading ...