Hantek DPO6004BC series oscilloscope

Hantek DPO6004B user manual - Page 77

For DPO6004BC.

PDF File Manual, 124 pages, Read Online | Download pdf file

DPO6004BC photo
Loading ...
Loading ...
Loading ...
DPO6000, MPO6000 Series Digital Fluorescent Oscilloscope Product Manual V1.3
74
large or too small).
[Setting]: Set the data source A and data source B to perform the measurement of
"Delay and Phase Parameters".
[Gating]: User-defined measurement range, indicated by cursor A and cursor B.
Measurement statistics
Statistic and display the current value, average value, maximum value, minimum value,
root mean square error and count value of the waveform parameters of the selected
data source.
Press [Type] and turn the multi-function knob V0 to select the waveform parameters to
perform measurement statistics.
Waveform parameters of measurement statistics can be displayed 4 kinds at a time,
and more than 4 kinds of waveform parameters will be covered and updated from bot-
tom to top.
[Clear all]: Clear all measurement data on the current display, including measurement
results, statistical results, and gate control.
Digital Voltmeter (DVM)
DPOO6000 / MPO6000 series oscilloscopes have built-in digital voltmeter (DVM) and
frequency meter, which can measure the voltage and frequency of analog channels,
and monitor the signal when the oscilloscope is running or stopped, which can improve
the user's counting and frequency measurement experience.
DVM performs 5-digit AC RMS, DC, AC + DC RMS voltage measurements and 6-digit
frequency measurements.
Press Meas-> Digital Voltmeter-> Enable on the front panel to turn on the digital volt-
meter;
[Data source] Select the data source to be tested.
[Type] Select the type of digital voltmeter display.
When DVM measurement is turned on, the display is as shown below. The DVM dis-
Loading ...
Loading ...
Loading ...