Loading ...
Loading ...
Loading ...
97
NAVI Chapter 10 Modifying the General Settings for Navigation Functions
Changing the unit between km
and miles
This setting controls the unit of distance and
speed displayed on your navigation system.
1 Touch [Settings] in the navigation menu,
then touch [Regional Settings].
2 Touch [km / mile] to change the setting.
Each time you touch the key changes that set-
ting.
[mile] (default):
Show distance in miles.
[Mile&Yard]:
Show distance in miles and yards.
[km]:
Show distance in kilometers.
Changing the virtual speed of
the vehicle
When calculating the expected time of arrival and
the number of hours to the destination, set the
average speed for the freeway or ordinary roads
using [+] and [–].
1 Touch [Settings] in the navigation menu,
then touch [Regional Settings].
2 Touch [Average Speed].
3 Touch [+] or [–] to set the speed.
❒ The estimated time of arrival is not neces-
sarily estimated based on this speed value.
Checking the Setting Related
with Hardware
The hardware status, including the driving status
of a vehicle, positioning status by satellite, learn-
ing status of the 3D sensor, and cable connection
status, can be checked.
Checking the connections of
leads and installation positions
Check that leads are properly connected between
the navigation system and the vehicle. Please
also check whether they are connected in the
correct positions.
1 Touch [Settings] in the navigation menu,
then touch [Hardware].
2 Touch [Connection Status].
The “Connection Status” screen appears.
(1) Speed Pulse
The Speed Pulse value detected by the naviga-
tion system is shown. [0] is shown while the
vehicle is stationary.
(2) GPS Antenna
Indicates the connection status of the GPS
antenna, the reception sensitivity, and from
how many satellites the signal is received. If
the signal is received correctly, [OK] is dis-
played. If reception is poor, [NOK] appears. In
such case, please change the installation
position of the GPS antenna.
(3) Phone Connection Status
Indicates the connection status of the Blue-
tooth unit (sold separately) and the signal
strength between the Bluetooth unit and the
cellular phone. If the Bluetooth unit is con-
nected correctly, [OK] is displayed. [NOK]
appears when the Bluetooth unit is not con-
nected or incorrectly connected.
(4) Installation Position
The installation position of the navigation sys-
tem is shown. That indicates whether the
installation position of the navigation system
is correct or not. If installed correctly, [OK]
appears. When the navigation system is
installed at an extreme angle exceeding the
limitation of the installing angle, [Incorrect
angle] will be displayed. When the angle of
the navigation system has been changed,
[Excessive vibration] will be displayed.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
CRB2297A_U_English.book Page 97 Friday, January 5, 2007 2:51 PM
Loading ...
Loading ...
Loading ...