Loading ...
Loading ...
Loading ...
193
AppendixNAVI/AV
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service center.
Abnormal Gyrosensoroutput is
detected.
Write down the error code shown on
the screen. Turn off the power, and
then contact your nearest Pioneer
service facility.
Positioning is not possible due to the
hardware. Please contact your dealer
or Pioneer service center.
The location display is not possible
due to hardware failure.
Consult your dealer.
GPS antenna problem detected.
Please contact your dealer or Pioneer
service center.
The location display is not possible
due to failure of the GPS antenna.
Consult your dealer.
This function is not available now. The screen cannot be displayed with
Vehicle Dynamics Display. The sen-
sor has not been taught so the sen-
sor information cannot be acquired.
If the sensor learning status reaches
the Sensor Initializing, the system is
ready to be used.
The vertical installation angle is
changed. Gyro Sensor calibration is
re-initialized.
If the mounting angle of the naviga-
tion unit has been changed.
The system initializes the sensor in
order to operate it with the maximum
performance and automatically
starts re-learning.
Excess vertical installation angle
detected. Please install the naviga-
tion unit correctly.
The navigation system is installed
with an extreme angle exceeding the
limitation of the installation angle.
Confirm the installation angle. (The
navigation system must be installed
within the allowed installation angle.
For details, refer to Installation Man-
ual.)
No data available at this time. No data is available that can be used
with the XM tuner.
Wait for a while and try the operation
again.
UPDATING (Updating) The selected channel is not included
in your subscription.
Select another channel.
Radio is being updated with the lat-
est encryption code.
Wait until the encryption code is fully
updated.
Route calculation was not possible. Route calculation has failed because
of a malfunction in map data, soft-
ware, or hardware.
• Change the destination.
• Consult the Pioneer Local dealer if
this message persists.
Route calculation not possible
because destination is too far.
The destination is too far. • Set a destination closer to the start-
ing point.
• Set one or more waypoints.
Route calculation not possible
because destination is too close.
The destination or waypoint(s) are
too close.
Set a destination and waypoint(s) far-
ther from the starting point.
Route calculation not possible due to
traffic regulations.
• The destination or waypoint(s) are
in a Control Traffic Zone (CTR) and
the route calculation is hampered.
• Your vehicle is currently in a Con-
trol Traffic Zone (CTR) and the
route calculation is hampered.
• Set a destination and waypoint(s)
outside the CTR if you know where
the restricted area is.
• Try a destination or waypoint(s)
away from the currently set points
to some extent.
• Drive your vehicle to an unre-
stricted area and reset the destina-
tion and waypoint(s).
Route calculation not possible
because navigation cannot be pro-
vided around destination or starting
point.
The destination, waypoint(s), or start-
ing point are in an area where no
road exists (e.g. a mountain) and the
route calculation is impossible.
• Set a destination and waypoint(s)
on roads.
• Reset the destination after you
drive the vehicle to any road.
Route to destination cannot be cal-
culated.
The destination or waypoint(s) are in
an isolated island, etc. without a ferry
and the route calculation is impossi-
ble. If there is no road connected to
your starting point or destination,
this message will appear.
Change the destination.
Message When What to do
CRB2297A_U_English.book Page 193 Friday, January 5, 2007 2:51 PM
Loading ...
Loading ...
Loading ...