User Manual - Page 385

For 2024 OUTBACK TOURING XT.

Loading ...
Loading ...
Loading ...
(381,1)
北米Model "A2630BE-A" EDITED: 2022/ 12/ 23
Gearshifts can be performed using the
shift paddle behind the steering wheel.
To upshift to the next higher gear position,
pull the shift paddle that has + indicated
on it. To downshift to the next lower gear
position, pull the shift paddle that has “−”
indicated on it.
To deselect the manual mode, return the
select lever to the “D” position from the “M”
position.
While driving with the select lever in the “D”
position, if you change gears by operating
the shift paddle, the gear position indicator
light illuminates and shows the current
gear condition.
CAUTION
Do not place or hang anything on the
shift paddles. Doing so may result in
accidental gear shifting.
NOTE
Please read the following points care-
fully and bear them in mind when using
the manual mode.
. If you attempt to shift down when the
engine speed is too high, i.e., when a
downshift would push the tach-
ometer needle beyond the red zone,
beeps will be emitted to warn you
that the downshift is not possible.
. If you attempt to shift up when the
vehicle speed is too low, the trans-
mission will not respond.
. You can perform a skip-shift (for
example, from 4th to 2nd) by operat-
ing the shift paddle twice in rapid
succession.
. The transmission automatically se-
lects 1st gear when the vehicle stops
moving.
. If the temperature of the transmis-
sion fluid becomes too high, the “AT
OIL TEMP” warning light will illumi-
nate. Immediately stop the vehicle in
a safe place and let the engine idle
until the warning light turns off.
& Driving Tips
s07bg05
NOTE
If the accelerator and brake pedals are
depressed at the same time, driving
torque may be restrained. This is not a
malfunction.
. On a road surface where there is a risk
of wheelspin (for example, a snow- or
gravel-covered road), you can pull
away from a standstill safely and easily
by first selecting the 2nd gear of the
manual mode.
. Always apply the foot or parking brake
when the vehicle is stopped in the “D” or
“R” position.
. Make sure to apply the parking brake
when parking your vehicle. Do not hold
the vehicle with only the transmission.
. Do not keep the vehicle in a stationary
position on an uphill grade by using the
“D” position. Use the brake instead.
. The engine may, on rare occasions,
knock when the vehicle rapidly accel-
erates or rapidly pulls away from a
standstill. This phenomenon does not
indicate a malfunction.
Continuously Variable Transmission
379
7
Starting and Operating
Loading ...
Loading ...
Loading ...