Loading ...
Loading ...
Loading ...
(373,1)
北米Model "A2630BE-A" EDITED: 2022/ 12/ 23
& Entering the Vehicle While It
Is Running via Remote Start
(Models with “Keyless Ac-
cess with Push-Button Start
System”)
s07az24
1. Unlock the vehicle doors using the
keyless access function and remote
keyless entry system.
NOTE
If the vehicle’s doors are unlocked
manually using the key, the vehicle’s
alarm system will trigger (if the alarm
system is armed prior to activating the
remote engine start system) and the
engine will turn off. Perform either of
the following procedures to disarm the
alarm system. Refer to “Alarm System”
�P146.
– Turn the push-button ignition
switch to the “ACC” or “ON”
position.
– Press any button on the access
key fob.
2. Enter the vehicle. The engine will
remain running provided the access
key fob is present and detected by the
vehicle.
3. Press the push-button ignition switch
once while depressing the brake pedal
before driving your vehicle. The remote
engine starter transceiver (fob) will
flash and beep 3 times to indicate that
the remote start system has been shut
down.
& Entering the Vehicle Follow-
ing Remote Engine Start
Shutdown
s07az10
An alarm trigger may occur if the vehicle is
opened by the remote keyless entry
transmitter within a few seconds immedi-
ately following remote engine start shut-
down.
& Pre-heating or Pre-cooling
the Interior of the Vehicle
s07az04
Before exiting the vehicle, set the tem-
perature controls to the desired setting and
operation. After the system starts the
engine, the heater or air conditioning will
activate and heat or cool the interior to
your setting.
& Remote Transmitter Program
(Remote Engine Starter
Transceiver)
s07az13
New transmitters can be programmed to
the remote engine start system in the
event that a transmitter is lost, stolen,
damaged or additional transmitters are
desired (the system will accept up to eight
transmitters). New remote engine start
transmitters can be programmed accord-
ing to the following procedure.
1. Open the driver’s door (the driver’s
door must remain open throughout the
entire process).
2. Depress and hold the brake pedal.
3. Turn the ignition switch to “ON” then
“LOCK”/“OFF”, back to “ON” then
“LOCK”/“OFF”, back to “ON” then
“LOCK”/“OFF”, then back to “ON”
again and leave the ignition “ON”
throughout the programming process.
4. The system will flash the side marker
lights, tail lights and parking lights and
honk the horn three times, indicating
that the system has entered the trans-
mitter learn mode.
5. Press and release the “
” button on
the transmitter that you want to pro-
gram.
6. The system will flash the side marker
lights, tail lights and parking lights and
honk the horn one time, indicating that
the system has learned the transmitter.
Upon successful programming, the
remote start confirmation transmitter
button will flash one time.
7. Repeat step 5 for any additional
transmitters (the system will accept
up to eight transmitters).
– CONTINUED –
Remote Engine Start System (Dealer Option)
371
7
Starting and Operating
Loading ...
Loading ...
Loading ...