Loading ...
Loading ...
Loading ...
(366,1)
北米Model "A2630BE-A" EDITED: 2022/ 12/ 23
CAUTION
. When the operation indicator on
the push-button ignition switch is
flashing in orange, there may be a
malfunction with the vehicle.
Contact a SUBARU dealer imme-
diately.
. If the indicator on the push-but-
ton ignition switch is flashing in
green after the engine has
started, it means that the steering
is still locked. While moving the
steering wheel right and left,
depress the brake pedal, and
press the push-button ignition
switch.
. Do not continue pressing the
push-button ignition switch for
more than 10 seconds. Doing so
could cause a malfunction. If the
engine does not start, stop press-
ing the push-button ignition
switch. Instead, press the push-
button ignition switch without
depressing the brake pedal to
switch the power status to
“OFF”. Wait 10 seconds, and then
press the push-button ignition
switch to start the engine.
NOTE
. When pressing the push-button igni-
tion switch while depressing the
brake pedal:
– The engine starter operates for a
maximum of 10 seconds and after
starting the engine, the starter
stops automatically.
– The engine can be started regard-
less of the power status.
. If the engine does not start, check
the security indicator light. Then
press the push-button ignition
switch without depressing the brake
pedal to switch the power to “OFF”.
– If the light had illuminated, try to
start the engine again.
– If the light had been off, press the
push-button ignition switch while
depressing the brake pedal more
forcefully.
. The engine start procedures may not
function depending on the radio
wave conditions around the vehicle.
In such a case, refer to “Starting
Engine” �P503.
. If the vehicle battery is discharged,
the steering cannot be unlocked.
Charge the battery.
. After the engine starts, the engine
speed will be kept high.
. It may be difficult to start the engine
when the battery has been discon-
nected and reconnected (for main-
tenance or other purposes). This
difficulty is caused by the electro-
nically controlled throttle’s self-di-
agnosis function. To overcome it,
keep the ignition switch in the “ON”
position for approximately 10 sec-
onds before starting the engine.
. Do not shift the select lever while the
starter is cranking.
1 Operation indicator
2 Push-button ignition switch
When the push-button ignition switch is
pressed while depressing the brake pedal,
the engine will start. The starting proce-
dure for the engine is as follows.
1. Carry the access key fob, and sit in the
driver’s seat.
Starting and Stopping Engine (Models with Push-Button Start System)
364
Loading ...
Loading ...
Loading ...