Loading ...
Loading ...
Loading ...
(266,1)
北米Model "A2630BE-A" EDITED: 2022/ 12/ 23
& Headlight Flasher
s03ah03
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
the lever. The headlight flasher works even
though the lighting switch is in the off
position.
When the headlights are on high beam, the
high beam indicator light “
” on the
combination meter also illuminates.
& High Beam Assist Function
s03ah07
NOTE
. The high beam assist function uti-
lizes the stereo camera installed at
the position of the front map lights.
. For details on how to handle the
stereo camera, refer to the Owner’s
Manual supplement for the EyeSight
system.
The high beam assist function automati-
cally changes the headlight from high
beam to low beam (or vice versa).
When all of the following conditions are
met, the headlight will change to high
beam.
. When the vehicle speed increases to or
above 20 mph (32 km/h).
. There is no preceding or oncoming
vehicle.
. The forward area of the vehicle is dark.
. The road does not have a sharp curve.
When any of the following conditions are
met, the headlight will change to low beam.
. When the vehicle speed decreases to
or below 10 mph (16 km/h).
. When the forward area of the vehicle is
bright.
. When there is a preceding or oncoming
vehicle.
. When the EyeSight system is malfunc-
tioning or is temporarily stopped.
NOTE
. Do not overestimate the capacity of
the high beam assist function. The
driver always has the responsibility
to understand the surrounding si-
tuation, to drive safely, and to
change the headlight mode manu-
ally if necessary.
. The factory setting (default setting)
for this function is set as “opera-
tional”. This setting can be changed
to OFF (non-operation) at SUBARU
dealers. For more details, contact a
SUBARU dealer.
! How to use the high beam assist
function
s03ah0701
The high beam assist function will be
activated when all the following conditions
are met.
. The light control switch is in the “AUTO”
position and the low beam headlights
are on automatically.
. The turn signal lever is pushed forward.
Light Control Switch
264
Loading ...
Loading ...
Loading ...