Loading ...
Loading ...
Loading ...
(364,1)
北米Model "A2630BE-A" EDITED: 2022/ 12/ 23
. The engine starts more easily when
the headlights, air conditioner and
rear window defogger are turned off.
& Starting Engine
s07bd01
CAUTION
Do not operate the starter motor
continuously for more than 10 sec-
onds. If the engine fails to start after
operating the starter for 5 to 10
seconds, wait for 10 seconds or
more before trying again.
NOTE
. It may be difficult to start the engine
when the battery has been discon-
nected and reconnected (for main-
tenance or other purposes). This
difficulty is caused by the electro-
nically controlled throttle’s self-di-
agnosis function. To overcome it,
keep the ignition switch in the “ON”
position for approximately 10 sec-
onds before starting the engine.
. Do not shift the select lever while the
starter is cranking.
CAUTION
If you restart the engine while the
vehicle is moving, shift the select
lever into the “N” position. Do not
attempt to place the select lever of a
moving vehicle into the “P” position.
1. Apply the parking brake.
2. Turn off unnecessary lights and acces-
sories.
3. Shift the select lever to the “P” or “N”
position (preferably “P” position). The
starter will only operate when the
select lever is at the “P” or “N” position.
4. Turn the ignition switch to the “ON”
position and check the operation of the
warning and indicator lights. Refer to
“Warning and Indicator Lights” �P183.
5. Turn the ignition switch to the “START”
position without depressing the accel-
erator pedal. Release the key immedi-
ately after the engine has started.
If the engine does not start, perform the
following procedure.
(1) Turn the ignition switch to the
“LOCK” position and wait for at
least 10 seconds. After checking
that the parking brake is applied,
turn the ignition switch to the
“START” position while depressing
the accelerator pedal slightly (ap-
proximately a quarter of the full
stroke). Release the accelerator
pedal as soon as the engine starts.
(2) If this fails to start the engine, turn
the ignition switch back to the
“LOCK” position and wait for at
least 10 seconds. Then fully de-
press the accelerator pedal and
turn the ignition switch to the
“START” position. If the engine
starts, quickly release the accel-
erator pedal.
(3) If this fails to start the engine, turn
the ignition switch again to the
“LOCK” position. After waiting for
10 seconds or longer, turn the
ignition switch to the “START”
position without depressing the
accelerator pedal.
(4) If the engine still does not start,
contact your nearest SUBARU
dealer for assistance.
6. Confirm that all warning and indicator
lights have turned off after the engine
has started. The fuel injection system
automatically lowers the idle speed as
the engine warms up.
While the engine is warming up, make sure
that the select lever is at the “P” or “N”
position and that the parking brake is
applied.
Starting and Stopping the Engine (Models without Push-Button Ignition Switch)
362
Loading ...
Loading ...
Loading ...