Loading ...
Loading ...
Loading ...
(280,1)
北米Model "A2630BE-A" EDITED: 2022/ 12/ 23
Compass calibration zones (South Amer-
ica)
3. To adjust for compass zone variance:
(1) Find your current location and
zone number on the map.
(2) Press and hold the “
” switch for
more than 6 seconds or until a
zone number appears in the dis-
play.
(3) Once the zone number appears in
the display, toggle the “
” switch
again until your current location
zone number appears. After you
stop pressing the switch, your new
zone number will be saved. Within
a few seconds, the display will
show a compass direction.
4. If the vehicle’s magnetics have chan-
ged or if the compass appears inaccu-
rate, recalibrate the compass. Press
and hold the “
” switch for more than
9 seconds or until a “C” appears in the
display. Once a “C” appears in the
display, slowly drive the vehicle in
circles until compass is calibrated.
! HomeLink
®
Wireless Control Sys-
tem
s03ap1003
The HomeLink
®
Wireless Control System
provides a convenient way to replace up to
three hand-held radio frequency remotes
used to activate devices such as gate
operators, garage door openers, entry
door locks, security systems, even home
lighting. The below steps are generic
programming instructions; for Genie and
Sommer garage door openers please go
directly to the HomeLink
®
website. Addi-
tional information and programming vi-
deos can be found at www.HomeLink.
com and www.youtube.com/HomeLink-
Gentex.
CAUTION
. Before programming HomeLink
®
to a garage door opener or gate
operator, make sure that people
and objects are out of the way of
the device to prevent potential
harm or damage.
. When programming a garage
door opener, it is advised to park
outside of the garage.
. Do not use HomeLink
®
with any
garage door opener that lacks
safety stop and reverse features
as required by U.S. federal safety
standards (this includes any gar-
age door opener model manufac-
tured before April 1, 1982). A
garage door that cannot detect
an object signaling the door to
stop and reverse does not meet
current U.S. federal safety stan-
dards.
. It is also recommended that a new
battery be placed in the hand-
held remote (garage door opener
remote) of the device for quicker
and more accurate training.
. Turn the ignition switch to the
“ON” or “ACC” position before
programming and/or operating
HomeLink
®
.
. Keep the hand-held remote (gar-
age door opener remote) of the
device you are programming for
use in other vehicles as well as
for future HomeLink
®
program-
ming. It is also suggested that
upon the sale of the vehicle, the
Mirrors
278
Loading ...
Loading ...
Loading ...