Loading ...
Loading ...
Loading ...
(297,1)
北米Model "A2630BE-A" EDITED: 2022/ 12/ 23
site.
! Gate Operator/Canadian Pro-
gramming
s03ap110803
Canadian radio-frequency laws require
transmitter remote signals to “time-out”
(or quit) after several seconds of transmis-
sion, which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian
law, some U.S. gate operators are de-
signed to “time-out” in the same manner.
The indicator LED on the hand-held
remote will go off when the device times
out, indicating that it has finished transmit-
ting.
If you live in Canada or you are having
difficulties programming a gate operator or
garage door opener by using the program-
ming procedures, replace “Programming a
New HomeLink Button” step 3 with the
following:
While the HomeLink indicator light is
flashing orange, press and release (“cy-
cle”) your device’s hand-held remote every
two seconds until the HomeLink indicator
light changes from orange to green. You
may now release the hand-held remote
button.
NOTE
If programming a garage door opener
or gate operator, it is advised to unplug
the device during the “cycling” process
to prevent possible overheating.
Proceed with “Programming a New
HomeLink Button” step 4 to complete.
! Using HomeLink
s03ap110804
To operate, simply press and release the
programmed HomeLink button. Activation
will now occur for the trained device (i.e.
garage door opener, gate operator, secur-
ity system, entry door lock, home/office
lighting, etc.). For convenience, the hand-
held remote of the device may also be
used at any time.
! Erasing HomeLink Buttons
s03ap110805
1. Press any of the left, center or right
buttons to select the main menu.
Select HomeLink menu using the left
button.
2. Select “SET UP” using the right button.
3. Select “Continue” using the HomeLink
left button.
4. Select the “Trash can icon” using the
HomeLink left button.
5. To erase the program for the HomeLink
button, select “Clear” using the
HomeLink center button.
HomeLink is now ready to be programmed
at any time beginning with “Programming a
new HomeLink button” - step 1.
! Reprogramming a Single
HomeLink Button
s03ap110806
To program a previously programmed
HomeLink button, refer to “HomeLink set
up” �P293.
– CONTINUED –
Mirrors
295
3
Instruments and Controls
Loading ...
Loading ...
Loading ...