Loading ...
Loading ...
Loading ...
SDS1000X-E User Manual
28
WWW.SIGLENT.COM
Vertical Position
Turn the
VERTICAL Position Knob
to adjust the vertical position of the channel waveform.
Turn the knob clockwise to increase the vertical position and the channel waveform
moves up while counterclockwise to reduce the vertical position and the waveform moves
down. Push the knob to set the vertical position of the channel waveform to zero.
During the adjustment, the vertical position information Volts Pos displays at the bottom of
the screen. The table below shows the range of vertical position according to the volt
scale.
Volt Scale
Range of Vertical Position
500 μV/div ~ 100 mV/div
±2V
102 mV/div ~ 1 V/div
±20 V
1.02 V/div ~ 10 V/div
±200 V
Coupling
Set the coupling mode to filter out the undesired signals. For example, the signal under
test is a square waveform with DC offset.
When the coupling mode set to
DC
: the DC and AC components of the signal under
test can both pass the channel.
When the coupling mode set to
AC
: the DC components of the signal under test are
blocked.
When the coupling mode set to
GND
: the DC and AC components of the signal under
test are both blocked.
Press the
CH1
button on the front panel; then press the
Coupling
softkey and turn the
Universal Knob
to select the desired coupling mode. The default setup is
DC
.
The current coupling mode is displayed in the channel label at the right side of the screen.
You can also press the
Coupling
softkey
continuously to switch the coupling mode.
Loading ...
Loading ...
Loading ...