Loading ...
Loading ...
Loading ...
SDS1000X-E User Manual
107
WWW.SIGLENT.COM
LIN Trigger
This part will provide a brief introduction and description for the operation of the LIN
trigger.
Trigger Conditions
Break
— the oscilloscope will be triggered at the position of break field’s break
delimiter.
ID
(Frame ID) — the oscilloscope will be triggered at the position of identifier field’s
stop bit, if the value of a frame’s ID is equal to specified value.
(
Note
: If the data’s value is 0xXX, any data value will be matched)
ID + Data
(Frame ID and Data) — the oscilloscope triggers when a frame with an ID
and data equal to the selected values is detected. Use the
Universal Knob
to select
the value for the ID, Data1 and Data2.
a. The ID’s value is the same as set value.
b. If you have set either Data1’s or Data2’s value, and the signal has a data is the
same as that value. If you have set both Data1’s and Data2’s value, the signal
should has two consecutive data, the first data’s value is Data1, second data
value is Data2.
(
Note
: If the data’s value is 0xXX, any data value will be matched)
Data Error
—the oscilloscope will be triggered when errors (such as ID check error,
checksum error, sync byte field error) are detected.
Operation Steps
1. Press the
Setup
button to enter the
TRIGGER
function menu.
2. Press the
Type
and select
Serial
.
3. Press the
Protocol
and select
I2C
.
4. Press the
Trigger Setting
softkey to enter
LIN TRIG SET
menu.
5. Press the
Condition
and select the trigger condition by
Universal Knob
:
If you select
ID
condition
:
a. Press the
ID
softkey and set its value by turning the
Universal Knob
.
If you
select
ID+DATA
condition
:
a. Press the
ID
softkey and set its value by turning the
Universal Knob
.
b. Press the
DATA1
softkey and set its value by turning the
Universal Knob
.
c. Press the
DATA2
softkey and set its value by turning the
Universal Knob
.
Loading ...
Loading ...
Loading ...