MX-M1100 User Manual

Loading ...

Initial Tab Copy Setting

This is used to set the default image shift width (tab

width) for tab copying.

The default width can be set from 0" (0 mm) to 5/8"

(20 mm) in increments of 1/8" (1 mm).

Disabling Deletion of Job Programs

This is used to prohibit the deletion and changing of copy

settings stored in job programs.

Disabling of Bypass-Tray in

Duplex Copy

This is used to prohibit the use of the bypass tray when

making two-sided copies.

The bypass tray is often used to feed label sheets,

transparency film, and other special media for which

two-sided copying is prohibited. If a sheet of one of these

special media enters the reversing unit, a misfeed or

damage to the unit may result. If special media for which

two-sided copying is prohibited is often used, it is

recommended that you enable this setting.

Disabling of Auto Paper Selection

This setting is used to disable the Auto Paper Selection

function.

When this setting is enabled, automatic selection of

paper that is the same size as the original on the

document glass or in the automatic document feeder

does not take place.

Auto Selection Setting of Tray that

is Supplied the Paper

When this setting is enabled and paper is loaded in a

tray while the machine is on standby in copy mode, that

tray is automatically selected.

600dpi x 600dpi Scanning Mode for

Document Feeder

The resolution used when scanning originals on the

document glass can be set to 600 x 600 dpi (high quality

mode).

When this setting is disabled, originals are scanned at

600 x 300 dpi.

When high quality mode is used, fine print and thin lines

are reproduced with greater clarity, however, the

scanning speed is slower.

Quick Scan from Document Glass

The resolution used when scanning originals on the

document glass can be set to 600 x 300 dpi (speed

priority mode).

When this setting is disabled, originals are scanned at

600 x 600 dpi.

When high speed mode is selected, the first copy time is

quicker, however, the copy image is not as clear.

When this setting is enabled to give priority to job

speed, the following conditions must all be met in

order for scanning to take place at the set resolution.

• The copy ratio must be set to 100%.

• Do not select a special mode that will change the

ratio.

When this setting is disabled to give priority to job