Loading ...
Loading ...
Loading ...
Mobile Printing Systems
CPCL Programming Manual
Section 15
Printer
Configuration
& Setup
pg. 15-8
RE-RUN Command
The RE-RUN command instructs the printer to execute the current le after an end-of-le is encountered.
Any format or command le in the printer, with the exception of AUTOEXEC.BAT and CONFIG.SYS, may use
the RE-RUN command.
GAP-SENSE & BAR-SENSE Commands
These commands are used to instruct the printer as to which means of top-of-form detection should be
employed. Printers default to BAR-SENSE if no command is specified. Printers that are not equipped with
a gap-sensor will attempt a pseudo gap-sense.
Format:
{command}
where:{command}: Choose one of the following:
GAP-SENSE # (0-255)
BAR-SENSE # (0-255)
Gap and Bar Sense commands can be followed by a number to adjust sensitivity. This is useful for gap
sense stock from vendors other than Zebra.
GAP-SENSE Command Example:
The following example configures the printer for gap-sensing. In addition, it specifies that the distance
from top-of-form to the gap is zero.
Input:
! UTILITIES
GAP-SENSE
SET-TOF 0
PRINT
continued
Index
Appendices
Loading ...
Loading ...
Loading ...