Loading ...
Loading ...
Loading ...
Mobile Printing Systems
CPCL Programming Manual
Section 14
Configuration/
Control
Commands
pg. 14-135
continued
wlan.current_essid
type: getvar
This parameter refers to the eSSID of the network currently associated with the printer. The eSSID is
returned only if the printer is associated with an access point.
getvar result
This will return the eSSID that the printer is associated with in Infrastructure
mode. When the printer is in Ad Hoc mode it will return the stored
eSSID. (For more information on Infrastructure and Ad Hoc modes see
“wlan.operating_mode”.)
Example
Description This command instructs the printer respond with the current
eSSID
Syntax ! U1 getvar “wlan.current_essid”
Result “ZebraNet”
Note: This parameter is not supported in units using a Frequency Hopping Spread Spectrum (FHSS) radio. The “wlan.essid”
parameter can be used instead.
wlan.current_tx_rate
type: getvar
This parameter retrieves the current transmit (tx) rate (mbps). This rate will vary depending on several
factors such as the Access Point’s settngs and the printer’s distance from the AP. Possible values are “1”,
“2”, “5.5”, and “11”.
getvar result Current transmit rate
Example
Description This command instructs the printer to respond with the current
tx rate
Syntax !U1 getvar “wlan.current_tx_rate”
Result “11”
Loading ...
Loading ...
Loading ...