Loading ...
Loading ...
Loading ...
Mobile Printing Systems
CPCL Programming Manual
Section 14
Configuration/
Control
Commands
pg. 14-83
continued
ip.dhcp.enable
type: getvar; setvar
This parameter refers to DHCP setting. DHCP must be set to “off” before setting a static IP address.
NOTE: It is not recommended that BOOTP and DHCP both be enabled at the same time since this may increase the printer power-up
initialization time. If both BOOTP and DHCP are enabled at the same time, the printer will rst try BOOTP and if it does not receive
a response after several seconds, it will then try DHCP. You should contact your network administrator to determine whether your
network supports either BOOTP or DHCP and enable only the proper parameter on the printer.
getvar result The printer printer’s DHCP status (on or off)
Example
Description This command instructs the printer to respond with DHCP setting
Syntax ! U1 getvar “ip.dhcp.enable”
Result “on”
setvar choices
“on”, “off”
Default “on”
Example
Description This command instructs the printer to enable DHCP
Syntax ! U1 setvar “ip.dhcp.enable” “off”
Result The printer’s DHCP will be off upon cycling printer power or
issuing the device.reset command
Loading ...
Loading ...
Loading ...