Loading ...
Loading ...
Loading ...
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
191
Parameter Description
State Select to enable or disable the automatic configuration of the IPv6 address
using stateless auto-configuration here.
Select the Default option to specify that if the default router is selected on this
interface, a default route will be installed using that default router. This option
can only be specified on one interface.
Click the Apply button to accept the changes made.
The fields that can be configured for Static IPv6 Address Settings are described below:
Parameter Description
IPv6 Address Enter the IPv6 address for this IPv6 interface here. Select the EUI-64 option to
configure an IPv6 address on the interface using the EUI-64 interface ID. Select
the Link Local option to configure a link-local address for the IPv6 interface.
Click the Apply button to accept the changes made.
The fields that can be configured for NS Interval Settings are described below:
Parameter Description
NS Interval
Enter the Neighbor Solicitation (NS) interval value here. The range is from 0 to
3600000 milliseconds, in multiples of 1000. If the specified time is 0, the router
will use 1 second on the interface and advertise 0 (unspecified) in the Router
Advertisement (RA) message.
Click the Apply button to accept the changes made.
The fields that can be configured for ND Settings are described below:
Parameter Description
Hop Limit Enter the hop limit value here. The range is from 0 to 255. The IPv6 packet
originated by the system will also use this value as the initial hop limit.
Reachable Time
Enter the Reachable Time here. The range is from 0 to 3600000 milliseconds. If
the specified time is 0, the router will use 1200 seconds on the interface and
advertise 1200 (unspecified) in the RA message. The Reachable Time is used
by the IPv6 node in determining the reachability of the neighbor nodes.
Managed Config Flag Turn the Managed Config Flag option On or Off here. When the neighbor host
receives the RA which has flag turned on, the host should use a stateful
configuration protocol to obtain IPv6 addresses.
Other Config Flag
Turn the Other Config Flag option On or Off here. By setting the other
configuration flag on, the router instructs the connected hosts to use a stateful
configuration protocol to obtain auto-configuration information other than the
IPv6 address.
RA Min Interval
Enter the minimum RA interval time value here. The range is from 3 to 1350
seconds. This value must be smaller than 0.75 times the maximum value.
RA Max Interval Enter the maximum RA interval time value here. The range is from 4 to 1800
seconds.
RA Lifetime Enter the RA lifetime value here. The range is from 0 to 9000 seconds. The
lifetime value in RA instructs the received host the lifetime value for taking the
router as the default router.
RA Suppress Select to enable or disable the RA suppress feature here.
Click the Apply button to accept the changes made.
After selecting the Interface IPv6 Address tab option, at the top of the page, the following page will be available.
Loading ...
Loading ...
Loading ...