Loading ...
Loading ...
Loading ...
590
Troubleshooting Guide
The access lamp still lights or blinks even
when the power switch is <
2
>.
●If the power is turned o while an image is being recorded to the
card, the access lamp will remain on or continue to blink for a few
seconds. When the image recording is complete, the power will
turn o automatically.
[Does this battery/do these batteries display
the Canon logo?] is displayed.
●Do not use any battery other than genuine Canon Battery Pack LP-
E6N/LP-E6.
●Remove and install the battery again (p.43).
●If the electrical contacts are dirty, use a soft cloth to clean them.
The battery becomes exhausted quickly.
●Use a fully-charged battery (p.40).
●T
he battery performance may have degraded. See [
5
3: Battery
info.] to check the battery’s recharge performance level (p.387). If
the battery performance is poor, replace the battery with a new one.
●The number of possible shots will decrease with any of the
following operations:
• Pressing the shutter button halfway for a prolonged period.
• Activating the AF frequently without taking a picture.
• Using the lens’s Image Stabilizer.
• Using the Wi-Fi/Bluetooth (wireless communication) function.
The camera turns o by itself.
●Auto power o is in eect. To deactivate auto power o, set [Auto
power o] under [
5
2: Power saving] to [Disable] (p.377).
●Even if [Auto power o] is set to [Disable], the screen and
viewnder will still turn o after the camera is left idle for the time
set in [Display o] and [Viewnder o], but the camera will
remain on.
●Set [
5
2: Eco mode] to [O].
Loading ...
Loading ...
Loading ...