Loading ...
Loading ...
Loading ...
518
Responding to Error Messages
11: Connection target not found
z
In the case of [
q
], is Camera Connect running?
g
Establish a connection using Camera Connect (p.442).
z
In the case of [
l
], is the power of the printer on?
g
Turn on the printer.
z
In the case of [
D
], is the EOS software running?
g
Start the EOS software and reestablish the connection (p.463).
z
Are the camera and the access point set to use the same
password for authentication?
g
This error occurs if the passwords do not match when the
authentication method for encryption is set to [Open system].
The setting is case-sensitive, so check upper- and lower-case
characters. Make sure that the correct password for authentication
is set on the camera (p.506).
12: Connection target not found
z
Is the power of the target device and access point on?
g
Turn on the target device and access point, then wait a while. If a
connection still cannot be established, perform the procedures to
establish the connection again.
Loading ...
Loading ...
Loading ...