Loading ...
Loading ...
Loading ...
Delete
Linkage
Sengs
Select the congured linkage sengs in the
device list and click Delete to delete it.
8.8.3 Congure Device Acons for Card Swiping
You enable access control device's linkage acons (such as
disarming a zone and triggering audio prompt) for the swiping of
a specic card, In this way, you can monitor the card holder's
behaviors and whereabouts.
Steps
Note
It should be supported by the device.
1. Click Access Control → Linkage Conguraon .
2. Select the access control device from the list on the le.
3. Click Add to add a new linkage.
4. Select Card Linkage as the event source.
5. Enter the card number or select the card from the drop-down
list.
6. Select the card reader where the card swipes.
7. In the Linkage Target area, set the property target to enable
this acon.
Buzzer on Controller
The audible warning of access control device will be
triggered.
Buzzer on Reader
The audible warning of card reader will be triggered.
Capture
An event-related picture will be captured when the selected
event happens.
Recording
An event-related picture will be captured when the selected
event happens.
Note
The device should support recording.
Alarm Output
The alarm output will be triggered for nocaon.
Alarm Input
Arm or disarm the alarm input.
Note
The device should support alarm input funcon.
Access Point
The door status of open, close, remain open, or remain
closed will be triggered.
Audio Play
75
Loading ...
Loading ...
Loading ...