Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/54577619-ds-k3b501sx/bg4a.png)
Note
If you change the persons' access informaon or other related
informaon, you will view the prompt Access Group to Be
Applied on the right corner of the client.
You can click the prompt to apply the changed data to the
device. You can select either Apply Now or Apply Later.
Figure 8-5 Data Synchronizaon
8.7 Congure Advanced Funcons
You can congure the advanced funcons of access control to
meet some special requirements in dierent scene.
Note
●
For the card related funcons(the type of access control card),
only the card(s) with access group applied will be listed when
adding cards.
●
The advanced funcons should be supported by the device.
●
Hover the cursor on the Advanced Funcon, and then Click
to customize the advanced funcon(s) to be displayed.
8.7.1 Congure Device Parameters
Aer adding the access control device, you can congure the
parameters of access control device, access control points.
Congure Parameters for Access Control Device
Aer adding the access control device, you can congure its
parameters.
Steps
1. Click Access Control → Advanced Funcon → Device
Parameter .
Note
If you can nd Device Parameter in the Advanced Funcon list,
Hover the cursor on the Advanced Funcon, and then Click
to select the Device Parameter to be displayed.
2. Select an access device to show its parameters on the right
page.
3. Turn the switch to ON to enable the corresponding funcons.
Note
The displayed parameters may vary for dierent access control
devices.
RS-485 Communicaon Redundancy
You should enable this funcon if you wire the RS-485 card
reader to the access control device redundantly.
Enable NFC
59
Loading ...
Loading ...
Loading ...