Loading ...
Loading ...
Loading ...
3. Select an access control device in the device list and click
RS-485 to enter the RS-485 Sengs page.
4. Select the serial port number from the drop-down list to set
the RS-485 parameters.
5. Set the serial number, peripheral, authencaon center, baud
rate, data bit, the stop bit, parity type, communicaon mode,
working mode, and connecon mode in the drop-down list.
6. Click Save.
●
The congured parameters will be applied to the device
automacally.
●
When you change the working mode or connecon mode,
the device will reboot automacally.
Enable M1 Card Encrypon
M1 card encrypon can improve the security level of
authencaon.
Steps
Note
The funcon should be supported by the access control device
and the card reader.
1. Enter the Access Control module.
2. On the navigaon bar on the le, enter Advanced Funcon →
More Parameters .
3. Select an access control device in the device list and click M1
Card Encrypon Vericaon to enter the M1 Card Encrypon
Vericaon page.
4. Set the switch to on to enable the M1 card encrypon
funcon.
5. Set the sector ID.
Note
●
The sector ID ranges from 1 to 100.
●
By default, Sector 13 is encrypted. It is recommended to
encrypt sector 13.
6. Click Save to save the sengs.
8.8 Congure Linkage Acons for Access
Control
You can congure dierent linkage acons for the event detected
by the access control device. Aer that, linkage acons will be
triggered once the event happens. This mechanism is used for
nofying the security personnel the event, or triggering
automac access control in real me.
Two types of linkage acons are supported:
●
Client Acons: When the event is detected, it will trigger the
acons on the client, such as the client making an audible
warning..
●
Device Acons: When the event is detected, it will trigger the
acons of a specic device, such as buzzing of a card reader
and, opening/closing of a door, ..
8.8.1 Congure Client Acons for Access Event
72
Loading ...
Loading ...
Loading ...