Loading ...
Loading ...
Loading ...
5. Some of the following parameters are not listed in the Basic
Informaon page, click Advanced to edit the parameters.
Duress Code
The door can open by inpung the duress code when there
is duress. At the same me, the client can report the duress
event.
Dismiss Code
Create a dismiss code which can be used to stop the buzzer
of the card reader (by entering the dismiss code on the
keypad).
Note
●
The duress code, super code, and dismiss code should be
dierent.
●
The duress code, super password, and the dismiss code
should be dierent from the authencaon password.
●
The length of duress code, super password, and the dismiss
code is according the device, usually it should contains 4 to 8
digits.
6. Click OK.
7. Oponal: Click Copy to , and then select the door(s) to copy
the parameters in the page to the selected doors(s).
Note
The door's status duraon sengs will be copied to the
selected door(s) as well.
Congure Parameters for Card Reader
Aer adding the access control device, you can congure its card
reader parameters.
Steps
1. Click Access Control → Advanced Funcon → Device
Parameter .
2.
In the device list on the le, click
to expand the door, select a
card reader and you can edit the card reader's parameters on
the right.
3. Edit the card reader basic parameters in the Basic Informaon
page.
Note
The displayed parameters may vary for dierent access control
devices. There are part of parameters listed as follows. Refer to
the user manual of the device for more details.
Name
Edit the card reader name as desired.
Minimum Card Swiping Interval
If the interval between card swiping of the same card is less
than the set value, the card swiping is invalid. You can set it
as 0 to 255.
Alarm of Max. Failed Aempts
Enable to report alarm when the card reading aempts
reach the set value.
61
Loading ...
Loading ...
Loading ...