Loading ...
Loading ...
Loading ...
1. Click Access Control → Linkage Conguraon .
2. Select the access control device from the list on the le.
3. Click Add to add a new linkage.
4. Select Event Linkage as the event source.
5. select the event type and detailed event to set the linkage.
6. In the Linkage Target area, set the property target to enable
this acon.
Buzzer on Controller
The audible warning of access control device will be
triggered.
Capture
An event-related picture will be captured when the selected
event happens.
Recording
An event-related picture will be captured when the selected
event happens.
Note
The device should support recording.
Buzzer on Reader
The audible warning of card reader will be triggered.
Alarm Output
The alarm output will be triggered for nocaon when the
selected event happens
Alarm Input
Arm or disarm the alarm input.
Note
The device should support alarm input funcon.
Access Point
The door status of open, close, remain open, or remain close
will be triggered.
Note
The target door and the source door cannot be the same
one.
Audio Play
The audio prompt will be triggered. And the select audio
index related audio content will be played according to the
congured play mode.
7. Click Save.
8. Oponal: Aer adding the device linkage, you can do one or
more of the followings:
Edit Linkage
Sengs
Select the congured linkage sengs in the
device list and you can edit its event source
parameters, including event source and
linkage target.
74
Loading ...
Loading ...
Loading ...