Loading ...
Loading ...
Loading ...
2-50 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Bolts, Nuts and Fasteners Tightness Inspection
•
Check the tightness of the bolts and nuts listed here. Also,
check to see that each cotter pin is in place and in good
condition.
NOTE
○
For the engine fasteners, check the tightness of them
when the engine is cold (at room temperature).
If there are loose fasteners, retighten them to the spec-
ified torque following the specified tightening sequence.
Refer to the appropriate chapter for torque specifications.
If torque specifications are not in the appropriate chapter,
see the Standard Torque Table. For each fastener, first
loosen it by 1/2 turn, then tighten it.
If cotter pins are removed, replace them with new ones.
Bolt, Nut and Fastener to be checked
Engine:
Clutch Lever Pivot Bolt Locknut
Engine Mounting Bolts and Nuts
Exhaust Pipe Manifold Holder Nuts
Exhaust Pipe Mounting Bolt
Muffler Body Clamp Bolts
Muffler Body Mounting Bolt and Nuts
Radiator Upper and Lower Bolts
Subframe Bolts
Wheels:
Front Axle
Front Axle Clamp Bolt
Rear Axle Nut
Brakes:
Brake Lever Pivot Nut
Brake Pedal Bolt
Brake Rod Joint Cotter Pin
Caliper Mounting Bolts
Front Master Cylinder Clamp Bolts
Rear Master Cylinder Mounting Bolts
Suspension:
Front Fork Clamp Bolts
Rear Shock Absorber Bolt and Nut
Swingarm Pivot Shaft Locknut
Swingarm Pivot Shaft Nut
Tie-Rod Nuts
Rocker Arm Nut
Steering:
Handlebar Holder Bolts
Steering Stem Head Bolt
Others:
Footpeg Bracket Bolts
Front Fender Bolts
Sidestand Bolt
Loading ...
Loading ...
Loading ...