Loading ...
Loading ...
Loading ...
14-12 STEERING
Handlebar
•
For other than US and CA models, align the punch mark
[A] on the handlebar and the corner edge [B] on the upper
holder.
•
Tighten:
Torque - Handlebar Holder Bolts [A]: 25 N·m (2.5 kgf·m, 18
ft·lb)
•
Install the handlebar holder plugs [B].
•
Apply adhesive cement to the inside of the left handlebar
grip.
•
Insert the throttle cables [A] into the throttle case [B].
•
Install the throttle cable holder plate [C].
•
Tighten the holder plate screw [D].
•
Install the throttle cable tips [A] to the throttle grip [B].
○
Fit the projection [C] into a hole [D] in the handlebar.
•
Apply a non-permanent locking agent to the threads of
the handlebar weight screws, and tighten them.
•
Install the left and right switch housings.
○
Fit the projection [A] into a hole [B] in the handlebar.
Torque - Switch Housing Screws: 3.5 N·m (0.36 kgf·m, 31
in·lb)
•
Install:
Front Master Cylinder (see Front Master Cylinder Instal-
lation in the Brakes chapter)
Clutch Lever Assembly (see Clutch Lever Assembly In-
stallation in the Clutch chapter)
Loading ...
Loading ...
Loading ...