Loading ...
Loading ...
Loading ...
9-24 CRANKSHAFT/TRANSMISSION
Crankshaft and Connecting Rods
Crankshaft Runout Inspection
•
Measure the crankshaft runout.
If the measurement exceeds the service limit, replace the
crankshaft.
Crankshaft Runout
Standard: TIR 0.02 mm (0.0008 in.) or less
Service Limit: TIR 0.05 mm (0.0020 in.)
Crankshaft Main Bearing Insert/Journal Wear
Inspection
•
Using a plastigage (press gauge) [A], measure the bear-
ing insert/journal [B] clearance.
NOTE
○
Tighten the crankcase bolts to the specified torque (see
Crankcase Assembly).
○
Do not turn the crankshaft during clearance measure-
ment.
○
Journal clearance less than 0.025 mm (0.00098 in.) can
not be measured by plastigage, however, using genuine
parts maintains the minimum standard clearance.
Crankshaft Main Bearing Insert/Journal Clearance
Standard: 0.010
∼ 0.034 mm (0.0004 ∼ 0.0013 in.)
Service Limit: 0.06 mm (0.0024 in.)
If the clearance is within the standard, no bearing replace-
ment is required.
If the clearance is between 0.035 mm (0.0014 in.) and the
service limit (0.06 mm, 0.0024 in.), replace the bearing in-
serts [A] with inserts painted blue [B]. Check insert/journal
clearance with the plastigage. The clearance may exceed
the standard slightly, but it must not be less than the min-
imum in order to avoid bearing seizure.
If the clearance exceeds the service limit, measure the
diameter of the crankshaft main journal.
Crankshaft Main Journal Diameter
Standard: 34.984
∼ 35.000 mm (1.3773 ∼ 1.3780 in.)
Service Limit: 34.96 mm (1.3764 in.)
If any journal has worn past the service limit, replace the
crankshaft with a new one.
If the measured journal diameters are not less than the
service limit, but do not coincide with the original diameter
markings on the crankshaft, make new marks on it.
Crankshaft Main Journal Diameter Marks
None
34.984
∼ 34.992 mm (1.3773 ∼ 1.3776 in.)
1
34.993
∼ 35.000 mm (1.3777 ∼ 1.3780 in.)
□: Crankshaft Main Journal Diameter Marks, “1” or no
mark.
Loading ...
Loading ...
Loading ...