Loading ...
Loading ...
Loading ...
BRAKES 12-55
Anti-Lock Brake System (Equipped Models)
•
Visually inspect the connector terminals [A].
Replace the ABS hydraulic unit or main harness if either
of the terminals are cracked, bent, or otherwise damaged.
If the ABS hydraulic unit connector is clogged with mud
or dust, blow it off with compressed air.
Front Wheel Rotation Sensor Removal
NOTICE
The wheel rotation sensor should be handled care-
fully, never struck sharply, as with a hammer, or al-
lowed to fall on a hard surface since the wheel rota-
tion sensor is precision made. Be careful not to get
water or mud on the wheel rotation sensor.
Do not try to disassemble or repair the wheel rota-
tion sensor.
•
Remove:
Upper Fairing (see Upper Fairing Removal in the Frame
chapter)
Connector [A] (Disconnect)
Grommet [B]
Clamp [C]
•
Clear the sensor lead from the clamp [A].
•
Remove:
Bolt [B]
Front Wheel Rotation Sensor [C]
Front Wheel Rotation Sensor Installation
•
Installation is the reverse of removal.
○
Run the lead correctly (see Cable, Wire, and Hose Rout-
ing section in the Appendix chapter).
Loading ...
Loading ...
Loading ...