Loading ...
Loading ...
Loading ...
SUSPENSION 13-29
Tie-Rod, Rocker Arm
Tie-Rod and Rocker Arm Bearing Removal
•
Remove:
Tie-Rods (see Tie-Rod Removal)
Rocker Arm (see Rocker Arm Removal)
Sleeves [A]
Oil Seals [B]
Swingarm [C] (see Swingarm Removal)
•
Remove the needle bearings [D], using the bearing re-
mover head and bearing remover shaft.
Special Tools - Bearing Remover Head,
15 × 17: 57001
-1267
Bearing Remover Shaft,
13: 57001-1377
Tie-Rod and Rocker Arm Bearing Installation
•
Replace the needle bearing [A] and oil seals with new
ones.
•
Apply 2-stroke oil to the inside of the tie-rod.
•
Apply plenty of grease to the lips of the oil seals.
•
Install the needle bearings and oil seals position as shown
in the figure.
○
Screw the needle bearing driver into the driver holder.
○
Insert the needle bearing driver into the needle bearing
and press the needle bearing.
7.5 mm (0.30 in.) [B]
NOTE
○
For a bearing of inner diameter
17, select the pressing
side of the needle bearing driver according to its press-
ing depth.
Special Tools - Bearing Driver Set: 57001-1129
Needle Bearing Driver,
17/ 18: 57001
-1609
Loading ...
Loading ...
Loading ...