Loading ...
Loading ...
Loading ...
APPENDIX 17-29
Cable, Wire, and Hose Routing
1. Insert the subharness connector to the clamp on the air suction valve cover.
2. Run the subharness under the hose.
3. Hose
4. Subharness
5. Run the subharness between the #1 and #2 throttle body holders so as not to pinch the lead
with the throttle body assy.
6. Install the clamp as shown in the direction.
7. Water Hose
8. Starter Motor Cable
9. Viewed from B
10. Water Temperature Sensor Lead
11. Hold the neutral switch/oil pressure switch lead with the clamp at the upside of the separate
pipe of the water pipe.
12. Run the neutral switch/oil pressure switch lead with the clamp at the rear side of the separate
pipe of the water pipe.
13. Connect the neutral switch lead to the neutral switch. Do not stretch the lead after connected.
14. Run the oil pressure switch lead to the inside of the water pipe.
15. Cover the oil pressure switch with the switch cover.
16. Hold the crankshaft sensor lead with the clamp.
17. Crankshaft Sensor Lead
18. Water pipe
19. Run the alternator lead between the crankcase and water pipe.
20. Viewed from A
Loading ...
Loading ...
Loading ...