Loading ...
Loading ...
Loading ...
APPENDIX 17-11
Cable, Wire, and Hose Routing
1. Fuel Injector Lead
2. Front
3. Hold the fuel injector lead with the clamp.
4. Hold the alternator lead and crankshaft sensor lead with the bracket.
5. Crankshaft Sensor Lead
6. Alternator Lead
7. Run the intake air temperature sensor to the upside of the crankshaft sensor lead.
8. Intake Air Temperature Sensor Lead
9. Oxygen Sensor Lead (Equipped Models)
10. Frame Ground
11. Starter Motor Cable
12. Run the fuel tank drain hose and fuel tank breather hose (other than CAL, SEA-B1 and TH
models) to the rear side of the sidestand switch lead and speed sensor lead, to the front side of
the frame ground leads, to the inside of the battery negative (–) lead, and to the outside of the
starter motor cable.
13. Fuel Tank Breather Hose (other than CAL, SEA-B1 and TH Models)
14. Fuel Tank Drain Hose
15. Speed Sensor Lead
16. Sidestand Switch Lead
17. Breather Hose
18. Run the fuel injection lead to the front side of the breather hose.
19. Install the damper so that the damper end fits the separating portion of the main harness as
shown.
20. Run the alternator lead and crankshaft sensor lead to the rear side of the breather hose.
21. Battery Negative (–) Cable
22. Run the alternator lead to the front side of the frame ground leads. Run the battery negative (–)
cable and starter motor cable to the rear side of the frame ground leads.
23. Run the battery negative (–) lead to the outside of the fuel tank breather hose (other than CAL,
SEA-B1 and TH models) and fuel tank drain hose.
24. Battery Negative (–) Lead
Loading ...
Loading ...
Loading ...