Loading ...
Loading ...
Loading ...
2-48 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Others
Chassis Parts Lubrication
•
Before lubricating each part, clean off any rusty spots with
rust remover and wipe off any grease, oil, dirt, or grime.
•
Lubricate the points listed below with indicated lubricant.
NOTE
○
Whenever the vehicle has been operated under
wet or rainy conditions, or especially after using a
high-pressure water spray, perform the general lubri-
cation.
Pivots: Lubricate with Grease.
Brake Lever
Brake Pedal
Clutch Lever
Rear Brake Joint Pin
Sidestand
Points: Lubricate with Grease.
Clutch Inner Cable Upper and Lower Ends [A]
Throttle Inner Cable Upper and Lower Ends
Cables: Lubricate with Rust Inhibitor.
Clutch Cable
Throttle Cables
•
Lubricate the cables by seeping the oil between the cable
and housing.
○
The cable may be lubricated by using a commercially
available pressure cable lubricator with an aerosol cable
lubricant.
Loading ...
Loading ...
Loading ...